ᐅ Tiling in a Level-Access Shower

Created on: 15 Apr 2024 22:26

domi1990

Good evening,
I’m looking for some suggestions for the tile pattern in my walk-in shower.
Since I have the linear drain installed diagonally in the corner, it’s been challenging to make this work in reality.
I managed to get the screed done quite well, thanks to this forum.
How would you lay the tiles in this shower?
The tiles measure 60 x 60 cm (24 x 24 inches).
Thank you very much in advance for your help.

View from above of a blue corner with drain grate and dirty floor; feet in red socks.

kbt0916 Apr 2024 22:26

#13

Well, there was this thread https://www.hausbau-forum.de/threads/walk-in-dusche-gefaelle-fuer-aussergewoehnliche-duschform.46991/ where @Nida35a already explained how it should be done.

domi199019 Apr 2024 07:53

#14

Okay, it seems quite a few mistakes were made here.
What do you think, is there still something that can be done? I would rather not tear everything out again since it has already been waterproofed.
Does anyone have any ideas?

kbt0919 Apr 2024 08:06

#15

Check if post 9 is still feasible. If not, you won't be happy with the shower without a slope.

domi199019 Apr 2024 08:14

#16

kbt09 schrieb:

Check if post 9 is still feasible. If not, you won’t be happy with the shower without a slope.

Ok, I will check it today. What could still be done if it’s not possible, so that it fits reasonably well?
I’m really starting to get frustrated.

ypg19 Apr 2024 11:34

#17

domi1990 schrieb:

Okay, I will check it today. What could still be done to make it fit reasonably well?
I’m really close to getting frustrated.

Honestly? Get a professional; anything else will be a botched job. I don’t see any slope installed in the screed from the tile near the shower towards the right and/or the back.
However, it could be misleading.

chand198619 Apr 2024 15:42

#18

kbt09 schrieb:

Check if post 9 is still feasible. If not, you won’t be satisfied with the shower without a slope.

Hmm... but that would be even more complicated than my idea, wouldn’t it? The tile joints would then run at an angle.

Without a slope in the screed, I really don’t see where the water would go.

So, directly to @domi1990:

Was the screed installed level, or with any slope?
If there is a slope, from where to where?

ᐅ Tiling in a Level-Access Shower

Reaktionen