Aloha!
A Pax is being planned and will be 3 meters long (10 feet). Ideally, I would like to assemble it from 1x1m (3.3x3.3 ft), 1x0.5m (1.6 ft), and 2x0.75m (2.5 ft) sections. However, the Pax brochure only shows combinations of carcasses with 1m (3.3 ft) and 0.5m (1.6 ft) widths. A customer service representative also mentioned that there might be issues with the sliding door fittings in this case.
Is she right? Are there other reasons why one half cannot be made from two identical 0.75m (2.5 ft) parts, or is it perhaps possible after all?
Thanks in advance,
PAXPaxpax
PS: It seems that UGGDAL is no longer available wider than 2m (6.6 ft) in total width. Are there specific reasons for this?
A Pax is being planned and will be 3 meters long (10 feet). Ideally, I would like to assemble it from 1x1m (3.3x3.3 ft), 1x0.5m (1.6 ft), and 2x0.75m (2.5 ft) sections. However, the Pax brochure only shows combinations of carcasses with 1m (3.3 ft) and 0.5m (1.6 ft) widths. A customer service representative also mentioned that there might be issues with the sliding door fittings in this case.
Is she right? Are there other reasons why one half cannot be made from two identical 0.75m (2.5 ft) parts, or is it perhaps possible after all?
Thanks in advance,
PAXPaxpax
PS: It seems that UGGDAL is no longer available wider than 2m (6.6 ft) in total width. Are there specific reasons for this?
Similar topics