Hello, we are currently renovating our bathroom.
The bathroom previously had a walk-in shower, but no slope was installed towards the drain. How could this be resolved?
I have attached a picture of the situation. It is a point drain that goes down vertically about 40 cm (16 inches). The shower area should remain as before, 120 x 120 cm (47 x 47 inches).
The bathroom previously had a walk-in shower, but no slope was installed towards the drain. How could this be resolved?
I have attached a picture of the situation. It is a point drain that goes down vertically about 40 cm (16 inches). The shower area should remain as before, 120 x 120 cm (47 x 47 inches).
Bloblu schrieb:
Hello, we are currently renovating our bathroom.
The bathroom previously had a walk-in shower, but there was no slope installed towards the drain. How could this be resolved?
I attached a picture of the situation. It is a point drain that goes down about 40 cm (16 inches) vertically. The shower area should remain as before, 120 x 120 cm (47 x 47 inches). The slope is created through the screed, so you would need to remove the screed and redo it if you want a level, flush shower floor.
Bloblu schrieb:
I’ve attached a photo of the situation. Where?
Similar topics