Hello everyone!
I have installed several edging strips using 20x10x8cm (8x4x3 inch) paving stones.
How would you fill the joints to prevent weeds from growing through them?
I have installed several edging strips using 20x10x8cm (8x4x3 inch) paving stones.
How would you fill the joints to prevent weeds from growing through them?
Golfi90 schrieb:
So, apparently not even a robot, right? That's correct. However, many also create mowing edges for their walk-behind mower.
It depends on the size of the garden. Every robotic lawn mower requires an edge strip to mow properly; otherwise, grass will be left uncut.
The larger all-wheel-drive models need wide edge strips.
However, some mowers can manage with an overhang of 12-15 cm (5-6 inches).
If there are no obstacles behind, edge strips are not necessary.
The larger all-wheel-drive models need wide edge strips.
However, some mowers can manage with an overhang of 12-15 cm (5-6 inches).
If there are no obstacles behind, edge strips are not necessary.
rick2018 schrieb:
It depends on the size of the garden. Every robotic mower requires an edge strip; otherwise, grass will remain uncut.
The larger all-wheel-drive models need wide edge strips.
Some mowers can manage with a 12-15cm (5-6 inches) overhang.
If there’s no obstacle behind, edge strips are not necessary. That’s exactly how it is.
This has little to do with the perimeter wire.