ᐅ What does it mean: Floor area ratio 0.4, plot ratio 1.2, number of storeys II - II?
Created on: 26 Jan 2016 14:32
J
juus1
Hello everyone,
I found a development plan while searching for a plot, but I cannot interpret it.
The following is specified for the plot:
Site coverage ratio 0.4
Floor area ratio 1.2
Number of floors II - III
1) What does this mean?
2) Would the Viebrockhaus Maxime 300 be considered a two-story house or just one story?
Thank you very much and best regards,
Yavuz
-------------------
link removed by moderation; please follow the forum rules.
Thank you!
Building Expert
I found a development plan while searching for a plot, but I cannot interpret it.
The following is specified for the plot:
Site coverage ratio 0.4
Floor area ratio 1.2
Number of floors II - III
1) What does this mean?
2) Would the Viebrockhaus Maxime 300 be considered a two-story house or just one story?
Thank you very much and best regards,
Yavuz
-------------------
link removed by moderation; please follow the forum rules.
Thank you!
Building Expert
Payday schrieb:
They must have considered the high floor area ratio and zoning levels II-III, and the neighboring houses will look similar. That’s correct. It is a large new development area, and there are no “one-and-a-half” story houses, as I would have preferred (one full floor on the ground level, a knee wall height of about 1.10 m (3.6 ft), and a 45° pitched roof). ALL houses built so far have two full floors.