ateliersiegel10 Jan 2022 15:08The bathroom is very small.
However, it still needs to fit a lot.
On one side of a partition wall for the shower, there is a sink.
What I want to figure out is what material the partition wall could be made of.
My plan is to bond two Fermacell boards together and tile both sides.
(Just for your information: one side ends at the room wall, the other side at a stainless steel pipe that is cut open on the side. The wall won’t be wide, about 40cm (16 inches). In the drawing, this is next to the quarter circle.)
My question: Is a Fermacell surface like this stable enough?
I assume it is 😎, but I have never done it myself or heard of anyone doing it 😱
… or are there completely different methods that I just haven’t come across yet?
However, it still needs to fit a lot.
On one side of a partition wall for the shower, there is a sink.
What I want to figure out is what material the partition wall could be made of.
My plan is to bond two Fermacell boards together and tile both sides.
(Just for your information: one side ends at the room wall, the other side at a stainless steel pipe that is cut open on the side. The wall won’t be wide, about 40cm (16 inches). In the drawing, this is next to the quarter circle.)
My question: Is a Fermacell surface like this stable enough?
I assume it is 😎, but I have never done it myself or heard of anyone doing it 😱
… or are there completely different methods that I just haven’t come across yet?
ateliersiegel10 Jan 2022 15:16Something went wrong... so far, I have not been able to delete the entire topic.
Similar topics