ᐅ Main structure of the multi-utility connection installed too deep
Created on: 22 Nov 2016 13:44
T
Tichu78
Hello,
our utility shaft was cast too deep. Now it is no longer watertight. Since all the service lines have already been installed, the manufacturer says it is no longer possible to seal it.
As the invoice for our shell builder is still outstanding, I am wondering what the best way to proceed is.
The defect was also not noticed by the site management.
Do you have any suggestions?
our utility shaft was cast too deep. Now it is no longer watertight. Since all the service lines have already been installed, the manufacturer says it is no longer possible to seal it.
As the invoice for our shell builder is still outstanding, I am wondering what the best way to proceed is.
The defect was also not noticed by the site management.
Do you have any suggestions?
Multimedia utility connection embedded too deep? That doesn’t happen with a single-family house.
Where pressurized water is expected, waterproof concrete and connection pipes with watertight continuous ribbed seals are used. Anything else will sooner or later cause problems.
Try searching for "watertight continuous ribbed seal."
Where pressurized water is expected, waterproof concrete and connection pipes with watertight continuous ribbed seals are used. Anything else will sooner or later cause problems.
Try searching for "watertight continuous ribbed seal."