ᐅ Base consumption district heating heat exchanger

Created on: 8 Nov 2022 20:43
M
MarieHB
Hello,
we currently do not heat yet, but we feel that the base consumption of our heat exchanger is too high. It also releases a lot of heat.
How many kWh are normal in this case without drawing any hot water?
The boiler is currently set to 60°C (140°F) due to concerns about Legionella.

Thank you very much for the information!
H
Hutchinson123
9 Nov 2022 15:24
I still need to check where the meter is located.
I should also reread the TAB if necessary.

How is it possible that comparable households get through the summer months with only 200 kWh?
We don’t have a hot water storage tank.

And how does it work with houses rated efficiency class A? Some of them have as little as 20 kWh or less per sqm/year.

For our nearly 100 sqm (1,076 sq ft) house, we already use almost 3,000 kWh per year without heating.
I find that quite high when you put it into perspective.

And back to the 2 kWh per day:
Those are on top of the 6 kWh standby load that is unused during absence.
But when we are at home, that 6 kWh doesn’t just disappear, since we are using some of it. So it can of course be a bit more than 2 kWh per day – okay.

We also shower only every other day, except in mid-summer.
Overall, I would consider us quite economical.
R
RotorMotor
9 Nov 2022 16:01
Hutchinson123 schrieb:

We do not have a hot water storage tank.
So, does warm water circulate continuously in the pipes?
H
Hutchinson123
9 Nov 2022 18:19
RotorMotor schrieb:

So warm water is circulating continuously in the pipes?

No, not directly like that.
The water is only heated when it is requested.
It can take up to a minute before warm water reaches the kitchen.
Patricck9 Nov 2022 18:19
MarieHB schrieb:

Hello,
we are not heating yet, but we feel that the base consumption of our heat exchanger is too high. It also emits a lot of heat.
How many kWh are normal without using any hot water?
The boiler is currently running at 60°C (140°F) due to legionella prevention.

Thank you very much for the information!

You mean legionella.

The question is, what settings are configured?
Patricck9 Nov 2022 18:35
In our system, the transfer station regulates the temperature according to the requirements. The legionella program is scheduled for Monday, during which the temperature is raised to 60°C (140°F). Otherwise, we maintain 200 liters (53 gallons) at 55°C (131°F), which is more than sufficient, even for bathing.
M
MayrCh
9 Nov 2022 18:42
Hutchinson123 schrieb:

The water is only heated when it is actually demanded.

Well, a domestic hot water station does draw a significant amount of power at peak times. That’s why most network operators prefer to minimize their presence in the network.