ᐅ Do not wire outlets and light switches in parallel.

Created on: 12 Jun 2019 14:13

Hello everyone,
is it common practice not to install electrical outlets and light switches flush with the wall surface? The developer considers gaps like those shown in the attached photo normal (the offset ranges between 0.5cm and 1.5cm (0.2 and 0.6 inches)). What are your thoughts on this?
Best regards

danixf14 Jun 2019 13:57

#19

apokolok schrieb:

Okay, the plastering will still need to be patched up.

Anything the electrician messes up has to be fixed by the painter... That’s how it always works for us.

Scorpy14 Jun 2019 14:53

#20

Were there any reasons why you couldn’t point this out earlier? At the stage of plastering over the electrical boxes, these could have been fixed very quickly.

lasa6427 Jun 2019 07:35

#21

Hello everyone, thanks again for your diligent responses. The electrician will check all the junction boxes once more and make any necessary corrections!

micric315 Jul 2019 17:10

#22

Hello, has there been any progress here yet?

lasa6416 Jul 2019 15:24

#23

Yes, everything has been corrected except for one spot.

ᐅ Do not wire outlets and light switches in parallel.

Reaktionen