P
peterbocholt17 Feb 2016 20:54So, forum, I have a question regarding full clinker tiles. I want to install them in my garage/workshop, about 60m² (645ft²), with very narrow grout joints like those used in industrial buildings/halls. There, these tiles are installed using a vibrating method. I plan to lay the tiles with flexible adhesive on a screed. Would this work? My main concern is the very narrow grout joints.
Requirements for the floor covering:
1. It must be suitable as a car parking area, so it needs the appropriate wear rating and slip resistance (R11).
2. It must be very durable and impact-resistant for workshop use, including welding work. The tiles should also be resistant to oil and gasoline.
3. The floor should look good since events are occasionally held there (although this is not the most important factor).
Requirements for the floor covering:
1. It must be suitable as a car parking area, so it needs the appropriate wear rating and slip resistance (R11).
2. It must be very durable and impact-resistant for workshop use, including welding work. The tiles should also be resistant to oil and gasoline.
3. The floor should look good since events are occasionally held there (although this is not the most important factor).
Similar topics