ᐅ KALLAX doors no longer fit properly after renovation – should they be adjusted?

Hello everyone, after a renovation I noticed that the doors on my KALLAX shelving unit no longer fit properly. The hinges now seem a bit strained, and the doors are hard to close or hang crookedly. My question is: Is there a way to adjust the KALLAX doors so they close cleanly and flush again? I suspect that the renovation – maybe a new floor or changes in the room – caused the frame to warp slightly. Has anyone had experience with readjusting KALLAX doors? Which screws on the hinges exactly need to be adjusted, and are there any tips for realigning the doors correctly? Thanks in advance for your input!

Yes, adjusting is possible with KALLAX doors. You need to loosen the screws on the hinge plates and move the door sideways or up/down. Just try it until the door fits.

To properly adjust the KALLAX doors, it helps to first understand the hinge mechanism in some detail. KALLAX doors typically use concealed hinges with cam screws that allow positioning the door along three axes: horizontal, vertical, and depth.

First, locate the adjustment screws on the hinges. Usually, there are 2-3 screws per hinge: one for lateral adjustment, one for height adjustment, and one for depth adjustment to move the door closer to or further from the cabinet body.

If your doors catch or stick, the lateral adjustment is often the most important to align the door panel parallel to the cabinet. The height adjustment is useful if the door rubs at the top or bottom or does not close flush.

One more important note: after a renovation, the cabinet body itself might be slightly warped. This means that even if you adjust the doors precisely, the frame or mounting surface might no longer be perfectly straight, which makes adjustments more difficult.

Could you please describe how much the doors are misaligned and whether the cabinet is stable? Are there any floor level changes, for example due to new flooring?

In short: Loosen the screws on the hinges, adjust the doors, then tighten the screws again. The most important screws are usually on the inside.

That sounds frustrating when something doesn’t fit anymore after the renovation! I can understand well how these small misalignments can be annoying. I had a similar issue with another piece of furniture – what helped me was to completely remove the doors, clean the hinges, and then slowly rehang and gradually adjust them. Maybe this is a good approach here too, so you have full control.

PAUREO54 schrieb:
Loosen screws and adjust doors

That is the basic approach, but I would also question why the doors no longer fit properly after renovation. Is the cabinet warped? Perhaps the floor was raised, causing the entire piece of furniture to wobble?

You should seriously check whether the furniture itself has been damaged or shifted due to changes in the space before simply adjusting the hinges. If the base is uneven, adjusting the hinges will just waste time.