Hello everyone,
Iâm planning to mount my IKEA Billy shelves on a drywall, but Iâm unsure how to do this securely and permanently without the shelves eventually falling down or damaging the wall. The wall is made of standard gypsum plasterboard fixed to a metal stud frame, and I want to use as strong fastening methods as possible since the shelves will be loaded with books and some weight.
What types of anchors or fasteners do you recommend for this setup? Should I pay attention to specific spacing? Are there any special heavy-duty anchors or other techniques that work particularly well?
I look forward to your tips and practical experience, and thank you in advance for the help!
Iâm planning to mount my IKEA Billy shelves on a drywall, but Iâm unsure how to do this securely and permanently without the shelves eventually falling down or damaging the wall. The wall is made of standard gypsum plasterboard fixed to a metal stud frame, and I want to use as strong fastening methods as possible since the shelves will be loaded with books and some weight.
What types of anchors or fasteners do you recommend for this setup? Should I pay attention to specific spacing? Are there any special heavy-duty anchors or other techniques that work particularly well?
I look forward to your tips and practical experience, and thank you in advance for the help!
LUISABEL schrieb:
You should try to align the back panel of the Billy shelves so that the screws go into the metal studs.That sounds logical. To what extent would you recommend removing or modifying the back panel to work more precisely? I am concerned that the shelfâs stability might be compromised by such alterations.
Alternatively, I was thinking about cutting a narrow section of the back panel on the wall side to recess the screws directly into the frame discreetly.
Does anyone have practical experience with fastening screws neatly into the profiles without major work on the back panel and without leaving unattractive marks visible afterward?
I didnât make any changes to the back panel during my installation. Instead, I pre-drilled and screwed the screws through the back panel into the metal studs. The screw heads are visible, but itâs minimal. If you want a cleaner finish, you can use small cover caps or customize the back panel accordingly and then repair it with wood filler.
Z
zarHenning2 Mar 2023 10:45Alternatively, you can use shelf brackets that are then screwed into the metal stud at the top or bottom. This way, you donât have to work on the back panel, and the back of the cabinet remains intact.
Naju56 schrieb:
Does anyone have practical experience with how to properly screw into the profiles without much effort at the back panel and without visible unsightly spots later?I would additionally recommend, if possible, completely removing the back panel and replacing it with a more durable plywood board. You can then attach this to the metal profile and also secure the shelves to itâthis better distributes the load and prevents point loads on the thin drywall panel.
This may sound complicated, but it improves safety and durability.
For those who donât want to do this, itâs best to use multiple screws directly into the profiles and distribute the load as evenly as possible there.
Davebla schrieb:
If possible, completely remove the back panel and replace it with a more durable plywood board.This makes sense, especially if the shelves need to hold many heavy books. Using plywood or MDF as the back panel provides significantly more stability when screwing and ensures better load distribution.
Make sure the replacement material is at least 10 mm (0.4 inches) thick and is securely fastened to the structure.
The effort is greater, but so is the safety.
Similar topics