Hello everyone,
some time ago I assembled an Ikea Brimnes wardrobe, but I’ve noticed that the screws, especially on the wardrobe doors, keep loosening over time. This causes the doors to no longer fit properly and to feel a bit wobbly. I suspect the material weakens over time due to the frequent opening and closing, which makes the joints less secure.
Has anyone had experience with how to best fix these loose screws without having to completely disassemble the wardrobe? Are there proven methods to secure the screws permanently or to reinforce the material? I would appreciate any specific instructions or tips, including recommendations for suitable tools or replacement parts.
some time ago I assembled an Ikea Brimnes wardrobe, but I’ve noticed that the screws, especially on the wardrobe doors, keep loosening over time. This causes the doors to no longer fit properly and to feel a bit wobbly. I suspect the material weakens over time due to the frequent opening and closing, which makes the joints less secure.
Has anyone had experience with how to best fix these loose screws without having to completely disassemble the wardrobe? Are there proven methods to secure the screws permanently or to reinforce the material? I would appreciate any specific instructions or tips, including recommendations for suitable tools or replacement parts.
If it’s not just about the screws but the clamping material, using threaded insert furniture fittings or so-called metal threaded bushings can help. You can screw these into pre-drilled holes and then fasten the furniture screws there. This significantly stabilizes the whole assembly.
Jorgela schrieb:
If it’s not just about the screws but also the clamping material, using threaded inserts or so-called metal threaded bushings can help.Exactly! It’s a bit like an upgrade for your furniture – replacing chipboard threads with metal ones. It’s a bit more effort, but if the cabinet is important to you, it’s definitely worth it. As an additional tip: when using metal threaded bushings, make sure to use the correct drill bits and drill slowly to avoid cracking the material.
Elias schrieb:
What helped me was filling the screw holes with wood filler and lightly sanding it after it dried. Then I could tighten the screws again without worrying about them coming loose.Thank you very much for this tip, Elias! That sounds very practical to me since it won’t significantly damage the surface of the cabinet. How well does the filler hold up with repeated opening and closing? Is it suitable for the screws on the doors as well, or more for the frame?
The idea of using metal threaded inserts also seems interesting. I will probably take a closer look at that, although I’m a bit cautious about potentially damaging the material.
Similar topics