ᐅ How can IKEA Platsa furniture be converted into a corner configuration?

Hello everyone, I am currently planning to convert my IKEA Platsa furniture into a corner configuration and have noticed that there is no clear instruction for this. I am particularly interested in how to connect the individual modules so that they are stable on one hand and at the same time make optimal use of the typical corner shape. Which connection methods are recommended to securely join the Platsa units together? Are there any special considerations regarding the back panels or the installation of doors when the furniture is placed together in a corner? In general, I would like to understand how the conversion of IKEA Platsa into a corner solution works: from measuring to final assembly. I appreciate any practical tips, experiences, or do’s and don’ts!

Hello jonman, your issue reflects a common challenge when converting IKEA Platsa units into corner solutions. Essentially, the individual modules are originally designed for linear arrangements, which means that you need to accept some adjustments when creating a corner setup. Here are some details and steps you should consider:

- Measurement: It is important to accurately measure the exact angle at the corner. Standard corners are 90 degrees, but you should rule out small deviations.

- Back panel technique: Most Platsa back panels are constructed as double layers to provide stability. In a corner, you can connect the back panels of the two units so that they meet at the corner, but you may need custom fabrication or trimming to avoid gaps.

- Connecting the modules: IKEA does not offer special corner connectors for Platsa, so screw-on metal brackets or hidden fittings that add stability are recommended. You should ensure the connection also allows some flexibility so that minor wall inaccuracies do not affect the assembly.

- Doors: When installing the doors, check whether the hinges interfere with each other when the units are placed directly against each other at the corner. It is often necessary to offset the hinges slightly or use spacers.

- Load distribution: Different forces act in a corner compared to straight assemblies, so it is important to ensure the floor is level and the units do not wobble.

Feel free to share more about your exact room dimensions and the number of modules, and I can provide more specific recommendations. How long are the planned sides? Are you using only 60 x 60 cm (24 x 24 inches) modules, or other sizes as well?

In summary, converting Platsa into a corner solution essentially involves the following steps:

- precise measurement, including room angles
- adjusting the back panels by cutting or replacing them, possibly with custom-made parts
- using sturdy metal brackets or special furniture connectors for the corner joint
- checking the hinges and door mounting options due to limited space
- occasionally using washers or spacers when the clearance is too tight

Based on my experience, it is advisable to gather and inspect all materials before assembly to avoid repeated disassembly. It is also recommended to use a tape measure, a spirit level, and, if necessary, a small square for optimal alignment at a 90-degree angle.

You take the modules, assemble them individually, connect them from the inside using suitable brackets, and, if necessary, adjust the back panels with a jigsaw. Leave some space between the doors so they do not block each other.

A sturdy metal angle bracket system is best suited for the connection. Back panels usually need to be trimmed at the corner to fit flush. Doors must be checked for misalignment; otherwise, the hinges may interfere with each other.

Domau0 schrieb:
Please provide more details about your exact room dimensions and the number of modules, so I can give you more specific recommendations. How long are the planned sides? Are you using only 60x60 cm (24x24 inches) modules or other sizes as well?

Why all the picky discussions about measurements? A 90-degree corner, done. Even if there’s a slight deviation, the materials can easily be adjusted with small shims. The back panel doesn’t necessarily need to be remade; a few millimeters won’t even be noticeable. People are just making things unnecessarily complicated.

I see it differently when it comes to doors: IKEA doors aren’t superior anyway, so just leave out the doors on one side, and there won’t be any issues with opening. Corner solution? Sure, a corner that gets used. Problem solved.