ᐅ Temporary construction power or permanent electrical connection? How much construction power is needed?

Hello everyone,

I have a quote from Edis for the “network connection in house connection pillar 100A” and the “commissioning of the network connection” for over €1,350.

To have construction power available, the meter and a distribution board are still missing, right?

Once the house is completed, the house connection pillar will be removed, and the connection will be routed into the house. That will cost an additional €300 to €500, correct?

My general contractor is building two more houses in the development and suggested that we share the construction power.

In that case, the house connection pillar would not be needed for my house, and I could connect the electricity directly inside the building as soon as it is finished. The question here is, would the cost again be around €300 to €500?

How much construction power is typically consumed on average?

Regards,
Denz

Little, if no crowns are operated, approximately 150 euros.

and a lot to very much if the screed heating is done via heat pump...

Scout schrieb:
and a lot to very much if the screed heating is done via heat pump...

Oh. Yes, we are installing a heat pump. What does "very much" mean for 190m² (2045 ft²)?

Is it actually possible to just put a small wood stove in for heating the screed?

We used a separate device for the screed heating program since the heat pump had not been installed yet at that time. However, I cannot say whether this was ultimately more cost-effective due to the lack of a comparison.

denz. schrieb:
Is it possible to just place a small wood stove inside to warm up the screed?

That was a good one...