ᐅ Use an Air Source Heat Pump or Gas and Solar?

Created on: 11 Jul 2012 19:15
G
gigi
Hello,

We are starting to get really frustrated... every builder tells us something different...

We want to build a 130sqm (1,399 sq ft) KfW 70 house with the living room facing south, and we are unsure whether to choose gas or an air source heat pump. Some providers, at almost the same price level, offer us air source heat pumps and claim that the annual costs are significantly (30%) lower compared to gas, while others doubt this.

We understand that insulation with gas/solar systems is usually better because an air source heat pump boosts efficiency more towards KfW 70 standards compared to gas/solar, which might argue in favor of gas. An air source heat pump might fail somewhat sooner, and in case of problems, you can usually get quick and competent local support with gas. With air source heat pumps, there could be more difficulties. Additionally, the noise of air source heat pumps (in our case about 3 meters (10 feet) from the neighbor) is not insignificant. Some say that sooner or later, everyone ends up having issues with neighbors for this reason.

We are interested in air source heat pumps with storage tanks from these providers: Vaillant, Mitsubishi Zubadan, and Rotex.

What we are really curious about is the annual cost for heating and hot water with both systems.

We live near Kassel.

What should we choose, and what would be cost-effective TODAY? What is your opinion on Vaillant?

Regards
Gigi
Mycraft25 Mar 2018 17:50
As I said, if I were you, I wouldn’t worry about it and would just install the simple collectors at 15° (15°).
R
R.Hotzenplotz
25 Mar 2018 17:51
Mycraft schrieb:
As I said, if I were you, I wouldn’t worry about it and just install the simple collectors at the 15° angle.

The general contractor will almost certainly not do that. They will build it according to the requirements of the energy saving regulations, based on the relevant calculations. If these calculations show that a specific angle is necessary, then that is what will be done. After all, they are responsible for complying with the energy saving regulations. There will be no shortcuts or “creative solutions” in this regard.
A
Alex85
25 Mar 2018 17:53
Then just one more, but without an angle. Provided that it is cost-effective.
Mycraft25 Mar 2018 17:56
Yeah, that could also be an idea.
R
R.Hotzenplotz
25 Mar 2018 17:59
I think that’s a good idea too. Let’s just see which is more cost-effective: pipes or one additional flat plate collector.
B
Bookstar
25 Mar 2018 19:52
So if you can get a ground source heat pump at that price, you really don’t need to think twice. What could be better? Do it!